If you think the battery is not durable, full use did not take long no electricity, battery jump quickly, you can use the following method:
Non-root phone : Keep phone switched on, connect charger (USB and charging cables are available) 2. Mobile LED turns green after the battery is fully charged, unplug the phone from the charger 3 Turn off the phone, and then Connect charger, charge your phone again to the LED light turns green 4. Unplug the phone charger
5 phone is switched on, until the phone is switched on and fully into the system, rapid shutdown
6 has been closed again, the charger is connected to the phone, wait a few minutes after the LED will turn green again
7 Unplug the phone from the charger
Boot normal use of mobile phones has gain root privileges:
The first method (recommended)
1 mobile phone run out of power, the phone reboot, waiting for spontaneous shutdown, this step is complete discharge
2 Connect the power remains off phone charging (charging time less than 12 hours, not power off during charging, otherwise you have to re-start the first step)
3 mobile phones to stay connected power status to boot into ** RE Manager or similar tool to remove / data / system / batterystats.bin this file, and then unplug the power immediately restart the phone
4 used normally until the battery died so far, can be used normally after
The second method
1 keep the phone switched on, connected to the charger
2 mobile phone LED turns green after the battery is fully charged, unplug the phone from the charger 3 Turn off the phone, then connect the charger, charge your phone again to the LED light turns green 4. Unplug the phone charger
5 phone is switched on, until the phone is switched on and fully into the system, rapid shutdown
6 has been closed again, the charger is connected to the phone, wait a few minutes after the LED will turn green again
7 Start the phone into recovery mode (hold down the Back key and power key phone starts), you can then choose wipebatterystats
The third method
A boot, connect the charger until the light turns green
(2) Unplug chargers, shutdown, connected to the charger until the light turns green
3 Unplug the charger, boot into the system, shut down, plug in the charger until the light turns green
(4) Unplug the charger, boot into recovery inside the advanced menu, you can restart after which wipebatterystatus
After following the steps above for battery calibration is complete, only charging more than usual took five minutes of time, but before and after calibration battery significantly different.
Before calibrating the battery you will find the battery is fully charged, the case will be dropped slightly to use about 93%, while the calibration can be maintained for several hours after the state began a 100% down to 99%, in short, the battery will definitely be calibrated surprise you.
Remarks :/ data / system / batterystats.bin This file is the system records including voltage including a variety of battery information, delete this file system will restart after battery usage statistics information. Recovery, "Wipe battery
status "to do is delete the / data / system / batterystats.bin this file This method deletes all records battery information, and cell phones to restore the factory is the same, the purpose is to allow the system to re-record the phone's current battery (battery must be allowed to reach saturation state) information, allowing the battery to achieve the best condition, so that the system full battery! Andrews battery calibration later on try not to replace the (frequent replacement of the battery charge information will lead to inaccurate Brush before fully charged battery can be reduced information error). additional root over the phone via recovery program wipebatterystats after better, but is not necessary.
Note that the battery calibration requires only once, several attempts to not let your battery activity again increased.
Blogger Comment
Facebook Comment